Maxon MODMAX MM-6280IND Instrukcja Użytkownika Pobierz pdf (Strona 7)

Kingfisher PLUS+ Installation Manual 2.6

www.cse-semaphore.com/mykingfisher

Page 7

5. Enclosure Layout

CAUTION! A RADIO SHOULD ONLY BE POWERED WHEN IT HAS AN ANTENNA CONNECTED.

THIS WILL PREVENT DAMAGE TO THE RADIO IF IT TRANSMITS.

All components of a Kingfisher PLUS+ RTU shall be installed inside of an enclosure providing safety

and environmental protection. The enclosure shall be made from metal or other material with a

flammability rating of V-0 or better in accordance with the requirements of the IEC 60950-1:2001

standard for a fire enclosure. An enclosure is not required to prevent fire hazard if the RTU is installed

above concrete or other non-combustible surface. Examples of enclosure layouts are shown below.

VENT MUST BE

INSTALLED IF

ENCLOSURE HAS A

BATTERY. INSTALL A

SECOND VENT IN

LOWER RIGHT HAND

CORNER IF BATTERY

IS > 26 AH OR IF

ENVIRONMENTAL

CONDITIONS

REQUIRE GREATER

AIRFLOW.

RADIO OR MODEM.

NOTE: RADIO CAN BE

MOUNTED ON REAR OF

DOOR BY USING DIN

RAIL. ENSURE THAT THE

RADIO IS MOUNTED ON

THE TOP LEFT HAND

CORNER OF THE DOOR

TO ALLOW THE RADIO

TO CLEAR THE RTU

MODULES WHEN THE

DOOR IS CLOSED.

INSTALL BACKPLANE LOW ENOUGH TO

ALLOW FOR AIRFLOW THROUGH MODULES.

GEARPLATE

BATTERY CAN REST

ON BOTTOM OF

ENCLOSURE OR A

BATTERY BRACKET

CAN BE USED

LIGHTNING ARRESTOR.

INSTALL HIGH ENOUGH TO

ALLOW EASY ACCESS FOR

ANTENNA LEAD

CONNECTION

LEAVE AT LEAST 30 mm

CLEARANCE TO ALLOW

ROOM FOR GLANDS AND

CABLES.

CABLE GLANDS MOUNTED

THROUGH GLAND PLATE

DOUBLE GPO. ONE

OUTLET FOR RTU. ONE

OUTLET FOR LAPTOP

IO WIRING TERMINALS

BATTERY

(MINIMUM 7 AH)

EARTH STUD. ENSURE

GPO, BACKPLANE AND

LIGHTNING ARRESTOR

ARE CONNECTED TO

THIS POINT USING

APPROPRIATE EARTHING

METHODS.

PSU-3

PC-1

IO-3

MC11

ENCLOSURE MUST NOT

CONTAIN OPENINGS IN

THIS AREA TO AVOID

FIRE RISK TO EXTERNAL

ENVIRONMENT

5 DEG

ENCLOSURE – RITTAL AE1045

500 HIGH x 400 WIDE x 210 DEEP mm

SLOTTED DUCT 20 X 60 mm

5.1 Battery and GPO Bracket

When using a 7 AH backup battery, a standard battery holder is available from your RTU supplier. The

bracket supports the battery and allows a General Power Outlet (GPO) to be mounted on the front

using M3 x 10 mm pan head screws. The battery holder also allows an ISB50LN lightning arrestor to

be mounted underneath.

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Komentarze do niniejszej Instrukcji

Brak uwag

Maxon MODMAX MM-6280IND Instrukcja Użytkownika Strona 7

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Maxon MODMAX MM-6280IND