Maxon WL7-vers. C Instrukcja Operatora Pobierz pdf (Strona 40)

PATENTS PENDING

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

ADJUSTMENTS

PLATFORM TILT ADJUSTMENT (MANDATORY)

NOTE: The platform tilt adjustment is important for operation of the outboard

rollstop and for keeping platform level when it reaches the ground. The

lift mounting surface must be parallel to the ground and rigid enough to

remain parallel during the adjustment process. Platform must be empty

during adjustment. Lift mounting surface must be parallel to ground and

bed height must be 29”. Vehicle ﬂ oor height, Lift and stiffness of the ve-

hicle suspension may change the angle of platform on the ground.

PLATFORM AT GROUND LEVEL WITH VERTICAL

ARMS RESTING ON FLATS

FIG. 40-1

POWER

SWITCH

1. Make sure power switch

(FIG. 40-1) is turned on.

2. Lower platform to just

above the ground with

enough room to place a

1/4” steel ﬂ at under bot-

tom of LH and RH vertical arms

(FIG. 40-1). Then, lower plat-

form until outboard rollstop is all

the way open and verti-

cal arms rest on the 1/4”

ﬂ ats.

VERTICAL ARM

(RH SHOWN)

1/4” FLAT

GROUND

3. Check for gap between tilt

adjuster screw and striker

or between striker and

vertical arm (FIG. 40-2). If

gap is between striker and

vertical arm, push striker

against vertical arm.

GAP BETWEEN TILT ADJUSTMENT SCREW

& STRIKER (RH SIDE OF PLATFORM SHOWN)

FIG. 40-2

SET SCREW

STRIKER

GAP

VERTICAL

ARM

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 73 74

Komentarze do niniejszej Instrukcji

Brak uwag

Maxon WL7-vers. C Instrukcja Operatora Strona 40

Komentarze do niniejszej Instrukcji